HOME > PRODUCTS > FULLY AUTOMATIC TUNGSTEN CARBIDE SAWING MACHINE
 
‧Servo-motor drive+ball screw feed
   transmission

‧Hydraulic driven sawhead feed for cutting
   motion

‧Feeding safety guard (optional)

‧Fully feeding safety guard (optional)
   
 

 
‧Servo-motor drive+ball screw feed transmission (Standard)

‧Sawhead driven by Servo-motor+Ball screw transmission for cutting (optional)

‧Feeding safety guard (optional)

‧Fully feeding safety guard (optional)
 
  The THC-70NC High Speed Tungsten Carbide Sawing Machine is designed and engineered to create optimum cutting performance. It features high speed, high efficiency, smooth surface of cut and high accuracy. The THC-70NC is especially ideal for cutting solid bars and angular steel. Also suitable for cutting steel pipe by using a HSS sawblade.

 
 
 

 
CUTTING CAPACITY TCT CARBIDE SAWBLADE / HSS SAWBLADE
Round solid bar mm
●10 ~ 65 (Ø70 opt)
Square solid bar mm
■10 ~ 57
Rectangle mm
▃▃10 ~57
Round pipe mm
○10 ~ 65
Square pipe mm
□10 ~ 60
Maximum length of head cut mm
10 ~ 60
Waste material length at tail end mm
65~(65+π cutting length)
Feeding length mm
5 ~ 600 Continuous cycles
Manually stack line-up loader capacity kg
2500
Material length mm
2000 ~ 6000
Material loading width mm
950
MACHINE SPECIFICATIONS
TCT carbide sawblade mm Ø250~Ø285xt2.0 (Ø285xt2.0xopt)
Pin holes+bore mm 4 xØ11xPCD63+Ø32
Tip aluminum carbide sawblade mm --
Pin holes+bore mm --
HSS sawblade mm Ø250~Ø285 / t2.0~t2.5 (4xØ11xPCD63+Ø32)
Spindle motor Kw 7.5 Kw~9 Kw (10HP~12HP) 4P
Spindle speeds rpm 17 ~ 200 rpm.
Frequency inverter   11Kw / 15 HP
Hydraulic pump motor Kw 2.2Kw (3HPx4P )
Operation pressure   7Mpa 70kg/cm2
Oil tank capacity ℓ 約100
Air pressure mpa  0.4 ~ 0.6 mpa 4 ~ 6kg/cm2
Feed drive   AC servomotor (1.3 or 1.5Kw) and precision ball screw
Sawhead drive   A. Material feeding and cutting is driven by hydraulic system.
B. AC servo-motor (1.8Kw or 2.0Kw) + ball screw transmission for cutting (optional)
Feeding vise   Horizontal hydraulic type
Main vise   Horizontal and vertical hydraulic type, one set each
MACHINE DIMENSIONS AND WEIGHT　
Machine size mm 6650 x 1450 x 1560
Weight (Machine+Feeder) kg 2500

*The manufacturer always performs product improvements to achieve the best possible performance.
  All specifications, dimensions and design characteristics shown in this catalogue are subject to change
  without notice. Product specifications are based on the actual machines. The manufacturer holds
  explanation rights.

 
  • Sawblade gap compensation device
  • Tungsten pad for sawblade run-out
  • Chip removing steel brush wheel
  • Screw type chip conveyor
  • Mist cooling device
  • Cutting fluid cooling device
  • Angular steel sliding device
  • Work light
  • TCT sawblade
  • HSS sawblade
  • TIP aluminum carbide sawblade
  • Mist collecting device
  • Cutting fluid
  • Angular steel slicing device